(Digital) gas bath oscillator a CHA-S (digital) air bath oscillator Introduction gas bath oscillator (also known as the air temperature shaker) is a temperature controlled gas tank and oscillator a combination of chemical and biological equipment, plant, biology, microbiology, genetics, viral, environmental, medical and other scientific research, education and production departments for preparation of sophisticated laboratory equipment is indispensable. Its main features are: (1) precise temperature control, digital display; (2) opened a Oxygenating hole; (3) a mechanical timer; (4) universal spring test bottle rack particularly suitable for a variety of biological samples for comparative tests culture preparation; (5) variable speed, smooth running, easy and safe to operate. Two CHA-S (digital) air bath oscillator Technical Specifications Model Temperature range (℃) oscillation amplitude (mm) oscillation frequency (rpm) Timing Range Total Power (W) Working Dimensions (mm) Dimensions (mm) ZD-85 from room temperature to 5020 (dual function) 0 ~ 300 0 ~ 120 580 440 × 360 710 × 470 × 520 SHZ-82 from room temperature to 5020 (swing) 0 ~ 300 0 ~ 120 580 440 × 360 710 × 470 × 520 CHA-S from room temperature to 5020 (reciprocating) 0 ~ 300 0 ~ 120 580 440 × 360 710 × 470 × 520 three CHA-S (digital) air bath oscillator 1 Before using, please read the details before using instructions. 2, the machine does not work plane over smooth (such as ceramic tiles, etc.). 3, an electrical socket rated user-supplied parameters should not be less than the unit's electrical ratings, and have a good grounding. 4 Do not use the machine in direct sunlight environment. 5, the governor should slowly start to low speed. 6, the machine may be some shift in the high-speed oscillation, and therefore should be used unattended. Four CHA-S (digital) use air bath oscillator 1, into the test bottle and keep the balance, and if so dual function models, set the oscillation mode. (Detailed settings see last icon) 2, power, set regular time scale based on machine surfaces, for working long hours, the timer is raised to "normally open" position. 3, turn on the power switch, set the thermostat temperature: (1) the control of small switch in the "Settings" section, the temperature at this time is set to display the temperature control knob to set the desired temperature that you are working available. (You set the operating temperature should be higher than the ambient temperature, then the machine begins to heat, the yellow light, otherwise the machine does not work) (2) the control part of the small switch in the "measured" side, then the display shows the temperature the actual temperature of the air in the test chamber, with the temperature changes inside the digital display will change accordingly. (3) when heated to your desired temperature, the heating will automatically stop, the green indicator light; When the test chamber heat dissipation, lower than the temperature you set, a new round will begin heating. 4, open the oscillating device: (1) Open the control oscillation switch on the control panel lights. (2) adjust the oscillation speed knob to the desired frequency of oscillation. 5, the work is completed off the power, set the speed control knob and temperature control knob to the lowest point. 6, cleaning machine, keep it clean. Five CHA-S (digital) air bath oscillator Note 1, the appliance should be placed in the more solid work surface, the environment should be clean and tidy, well-ventilated. 2, users should have good power outlet grounding. 3, non moving the machine when working properly. 4, is strictly prohibited objects hit the machine. 5, is prohibited for children close to the machine, to prevent accidents. 6, replace the fuse should be preceded sure the power is off. 7, please clean up after using the machine, you can not leave water droplets, dirt residues.